Product Manual

3. Secure yoke (to supports)

ATTENTION

Ensure the position locking pin is secured prior to attaching the fan yoke to the supports.

Attach the fan yoke to the supports with the Wall/Column Mount Hardware. Tighten the nuts.

After installation, the fan must be inspected to verify it is suciently secured to the column. Depending on the size

and surface of the column, the fan may be more prone to rotate if subjected to a lateral force.

Wall/Column Mount Hardware:

a. (1) 3/4-10 x 3-1/2” Hex Bolt

b. (2) 3/4” Flat Washer

c. (1) Yoke Attachment Bracket

d. (1) 3/4-10 Nut

4. Secure safety cable

WARNING: The safety cable is a crucial part of the fan and must be installed correctly. If you have any

questions, call Customer Service.

• Route one end of the safety cable through a

Gripple

, and then loop the cable around the

fan yoke and back through the Gripple.

• Route the cable through the second Gripple,

around the column, and then back through

the second Gripple.

• Pull the loose ends of the cable through the

Gripples until the cable is drawn tightly around

the column and fan yoke.

• Secure the loose ends of the cable with the

two (2) wire rope clips and torque to 4.5 ft·lb

(6.1 N·m).

Proceed to “Electrical Installation.”

Note: To back the safety cable out of the Gripple, insert a

1/16” (1.5 mm) Allen wrench into the small hole on the Gripple.