Product Manual

MOUNTING STRUCTURE: WALL

WARNING: The fan should not be installed unless the structure on which the fan is to be mounted is

of sound construction, undamaged, and capable of supporting the loads of the fan and its method of

attachment. Verifying the stability of the mounting structure is the sole responsibility of the customer and/

or end user, and Big Ass Fans hereby expressly disclaims any liability arising therefrom, or arising from

the use of any materials or hardware other than those supplied by Big Ass Fans or otherwise speciﬁed in

these installation instructions.

CAUTION: It is your responsibility to comply with all local and national codes and regulations regarding

mounting procedures and installation height!

CAUTION: Do not install the Wall/Column Mount from a ceiling or any other building structure that is not

a wall or a column. Consult a structural engineer for mounting conditions that are not covered in this

installation manual!

The safety cable must be installed if mounting the fan to a wall.

Yellow Jacket

can be mounted to a wall surface that is free of foreign objects that may interfere with the fan. The

following instructions are merely a recommendation for mounting the Yellow Jacket on a wall. Consult a structural

engineer to determine the best method for mounting your fan.

1. Attach supports (to wall)

ATTENTION

Consult a structural engineer to determine the required hardware, which should be of sucient strength

and quantity to support the weight of the fan and its method of attachment. It is the installer’s responsibility

to verify the adequacy of the wall and mounting hardware.

Select a mounting location that is free of foreign objects that may obstruct airﬂow. Attach the supports to a ﬂat wall

surface using installer-supplied hardware, orienting the supports as shown below.

Note: All hardware used to mount the supports is installer-supplied. Big Ass Fans cannot provide speciﬁc

installation details because of the wide variability of mounting surfaces, conditions, and fastening methods.

Consult a structural engineer to determine the required hardware.

Attach the supports in the orientation shown above. Do not mount the supports vertically!