Use and Care Manual

USA
BIGASSFANS.COM
877-244-3267
CANADA
BIGASSFANS.COM/CA
844-924-4277
AUSTRALIA
BIGASSFANS.COM/AU
1300 244 277
SINGAPORE
BIGASSFANS.COM/SG
65 6709 8500
MALAYSIA
BIGASSFANS.COM/SG
603 5565 0888
© 2020 Delta T LLC dba Big Ass Fans. All rights reserved. | ES6-MISC-135-ENG-01 REV. B | 07/22/2021
es6 FAN MAINTENANCE
Need more help?
Visit bigassfans.com/support
or call us at 855-694-2458
Please take a few moments each year to perform the following preventative maintenance
procedures on your fan to ensure its safe and ecient operation. If you have questions, require
assistance, or need replacement parts, please contact us at 1-855-694-2458.
CHECK SAFETY CABLE
Check that the safety cable is properly installed by removing the canopy screws, sliding the
canopy down the downrod, and examining the safety cable and hardware.
CHECK HARDWARE
Make sure the mounting hardware and the screws securing the airfoils to the fan hub are
securely fastened. Tighten the six airfoil screws on the bottom of the fan according to the
numbered sequence. When finished, repeat the tightening sequence.
CHECK WIRING
Make sure the wire connectors are secure and the ground wires are securely connected.
CLEAN AIRFOILS
Dust the airfoils regularly. If the fan becomes dirty, clean it with a damp cloth and ordinary soap
and water. Do not use solvents, gasoline, or any other chemical cleaners! These may cause
surface distortion and damage to the fan.
CLEAN UPLIGHT (IF INSTALLED)
Clean the LEDs periodically to ensure optimal performance. Use a compressed air duster to
remove dust and debris from the LEDs. Do not touch the LEDs while cleaning. Hold the duster
can upright when using.

Summary of content (2 pages)