Installation Guide

REV. A | 08/30/20214
3. Install uplight (optional) (cont.)
Skip this step if you are not installing the uplight.
Tighten the two set screws at top of uplight. Connect uplight wiring harness to motor
unit wiring harness. Connect downrod wiring harness to receptacle on uplight (Fig. 3.3).
Fig. 3.3
4. Reduce slack
Make sure all hardware is secure, and then gently tug cables at top of downrod to
reduce slack (Fig. 4).
Fig. 4
Uplight Wiring
Harness to Motor
Unit Wiring Harness
Downrod Wiring
Harness to Uplight
Receptacle