Installation Guide

DIRECT MOUNT CONT.

D5. Mount the ﬁxture to two wall or ceiling joists using two suitable #8 or #10

mounting screws. Mount the screws in holes A and C or holes B and D in the top

of the ﬁxture. Each set of holes is 16 in. (406 mm) apart. Holes B and C can also be

used to mount the ﬁxture directly to an outlet box or to parallel joists.

D6. Close the driver access door by seating it in the notch in the back of the

ﬁxture. Tighten the two captive screws.

D7. Reconnect the wiring harness and push it inside the yellow end cap of the light

module. Lift the light module into position and rotate it to the desired angle.

D8. Turn the screws on the ends of the ﬁxture clockwise to secure them.