Installation Guide

ALL RIGHTS RESERVED. І TOUS DROITS RÉSERVÉS. І TODOS LOS DERECHOS RESERVADOS.
3
FLUSH MOUNT CONT.
B1. Loosely thread the remaining two hex head screws into the screw holes on the
slotted mounting plate, leaving at least a 1/4 in. (6 mm) gap.
B2. Hang the fixture from the slotted plate with the provided S-hook as shown and
connect the power wiring. Push the wiring up into the outlet box.
C1. Raise the fixture and disengage the S-hook. Align the hex head screws on the
slotted plate with the keyhole slots on the fixture plate. Twist the fixture to secure.
Tighten the hex head screws.
Figure B1Figure B2
Figure C1
Figure B
10-32 x 3/8 in. Screw
1/4 in.
(6 mm)
Figure C