Instructions / Assembly

5 | P a g e
VENTAMATIC, LTD. P.O. Box 728, Mineral Wells, TX 76068-0728 • PHONE [phone] • WWW.BVC.COM

 Adjust the safety cable to the desired length. It is recommended to attach a safety cable near the mounting
bracket to a secure mounting point to allow the hanger cover to cover the safety cable as well as the hanger.
HANGING THE FAN MOTOR ASSEMBLY
 Lift the fan assembly onto mounting bracket. Fig. 4
 The hanger bracket has two screws on the bottom with key holes that are designed to hold the cover. See
Photo 7. When the holes are lined up, tighten the screws to keep the cover in place. Access to the screws are
hidden by a plastic cover that snaps in or out. When the screws are tight, slide the plastic hide strip back up the
downrod and snap back into place.
 Ensure the notch of the ball joint is positioned on the stopper of the mounting bracket to prevent the fan from
rotating when in operation. Fig. 5
Photo 5: Safety cable attached near hanger
Photo 6: Complete hanger assembly
Photo 7: Key holes on the bottom of the hanger cover.