Instructions / Assembly

4 | P a g e
VENTAMATIC, LTD. P.O. Box 728, Mineral Wells, TX 76068-0728 • PHONE [phone] • WWW.BVC.COM
DOWNROD AND HANGER ASSEMBLY
 Prior to assembly slide hanger cover (1A) and canopy cover (3A) onto downrod (2A). Hanger cover will be
facing ceiling to cup over mounting bracket and canopy cover will face down to cover motor screws.
 Run the black and white wires and safety cable through the center of the downrod (2a). Use the gold keeper pin
(Photo 4) to connect the motor to the downrod. Where the downrod attaches to the motor there are two set
screws that must be installed and tightened. If you fail to tighten these bolts the fan will seem to be out of
balance. These bolts MUST BE TIGHT. See Photo 3 to see these two bolts.



Hanger Cover 1A
Canopy Cover 3A
Down Rod 2A
Photo 2: Running wires through the center of the
downrod
Photo 3: Motor end where two bolts and safety pin
attaches
The hole on the black bracket
between the bolts is where the gold
pin attaches. See Photo 4.
Photo 4: Gold Keeper Pin