INSTALLATION Required tools for installation. Please have these tools prepared prior to installation. (Diana) Silicone gun Teflon tape Marking pen & or WA (Spanner model 55 oes J J) B varies for different Measuring tape Measuring cup pipes) t (Confirm all are included in the box) Intelligent toilet(1 set) T-valve(1 pc} Remote controller set(1 set) Fre installed 0 * adapter 20).
BEFORE YOU INSTALL Water pressure check, dimensional drawing. Checking your water supply The lowest working water pressure is 0.08MPa, the highest water pressure is 0.75MPA, the toilet can not reach the best clean situation when the lowest water pressure can not reach 0.08BMPA. Confirm dimensions of product with installation space Unit: inches Wall 1575 2697 18.5 © Drain hole distance to wal 12in Side profile Front view Top view BidetMate.
INSTALLING YOUR PRODUCT Install your unit using the Following steps 1 Open the box right side up Remove the accessories first, then remove the unit from the top, as shown in the diagrams below. Smart Toilet Mark your drainage hole with a cross 1. Align the flange with the drain hole, and 2.
Install the ceramic body, water supply hose and water filter 1. Place the wax ring on the drain hole at the bottom of the ceramic. 2. Align the ceramic drain with the drain hole on the ground, and press down to make the wax ring fully contact with the ground. 4. Attach the flush water hose to the T-valve and tighten. Clean water hose 3. Fix the two sides of the ceramic with two bolts, and finally install the cap. Flush water hose 8. Connect the T-valve to the water supply and tighten.
Installing the remote 1.Drill two inch) diameter holes on the wall (about 1.77 in deep) 2 Knock the anchors into the hole with a hammer. 3.Secure the holder with anchors. 4. Use the screws to secure the holder to the wall. 5.Remove the battery cover from the backside of the remote to install batteries 6.0nce finished, remote is ready to be placed in its holder. Detailed steps shown in the diagram below: X Please use proper mounting tools for special wall surfaces(such as wood, HDF, etc.
