Installation guide

Page Field Descriptions 461
System > Switch > Cut-through Paging
Field Description
Enable cut-through
paging
Select to enable cut-through paging.
Cut-through page ID
The system ID for cut-through paging. This system ID is
used with one-key dialing. For example, $CUT.
Cut-through page type
There are three types of cut-through paging:
• Attended. After placing the caller on hold, the
messaging system dials the subscriber’s pager and sends
the phone number. The system then reports whether this
call was successful before closing the call.
• Release. The messaging system transfers the caller to
the subscriber’s paging service and ends the call.
• Unattended. The messaging system sends the caller’s
phone number to the subscriber’s pager and ends the call
without confirming whether the call was successful.
Dial out to paging
service on same port
that handled call.
Select to have the system use only one port for cut-through
paging. Clear the box to use two ports.
Cut-through page
initiate sequence
The transfer sequence used to transfer the call for
cut-through paging.
Keep this field blank to use the call transfer initiate sequence
set on the Dialing Codes page. See “Configuring Dialing
Codes.”
Cut-through page recall
sequence
The recall sequence for cut-through paging. Keep this field
blank to use the call transfer recall sequence set on the
Dialing Codes page. See “Configuring Dialing Codes.”