Installation guide

Page Field Descriptions 439
System > Fax Setup
Field Description
CSID
The call station ID that appears in the TTI line of a fax sent
from the system. This is the fax phone number.
NOTE
THIS SETTING APPLIES TO ALL FAX PORTS AND IS SHARED BY
BOTH FAX MAIL AND FAX-ON-DEMAND.
Additional TTI
Select to configure the system to add a second TTI line at the
top of each fax mail. The system prints two lines at the top of
each page; the delivery information (from the messaging
system to the recipient) and the original transmission
information (from the sender to the messaging system).
Max pages per delivery
The maximum number of pages allowed per fax delivery.
When a single fax exceeds the maximum number of pages,
the system divides the fax into separate sets.
The maximum number of pages is 999. The minimum
number is five pages.
Fax outdial access
The outdial access number dialed to get an external line. The
default setting for the outdial access code is 9, (comma). The
outdial access number is not used when the fax delivery
number has fewer digits than the outdial trigger length.
Fax connect wait-time
Sets the number of seconds the messaging system waits for
a fax tone after dialing out.
Attempts per set
Sets the maximum number of attempts in a set. These
attempts are performed the system receives busy signal.
NOTE
FAX MAIL USES THE RETRY SETTINGS ONLY FOR FAX
DELIVERIES REQUESTED BY THE SUBSCRIBER. FOR
AUTOMATIC FAX DELIVERIES, THE SYSTEM USES THE FAX
DELIVERY SCHEDULE SHOWN IN THE SUBSCRIBER'S
NOTIFICATION WINDOW.
Delay between sets
The interval, in minutes, between each set of attempts.
Number of sets
Specifies the number of sets of delivery attempts the system
makes to deliver a failed fax.
Trim Top of Document
Controls how much vertical space is trimmed from the top of
a fax document. Transmitted faxes include the TTI line at the
top of each faxed page. This information can be removed
from the top of fax cover sheets by typing a trim amount in
hundredths of an inch. For example, type 100 to remove 1
inch (or 2.54 cm).
Wait ring
Specifies the number of rings the messaging system waits
for a connection after dialing out.