Installation guide

UNIVERGE

UM8000 Message Networking 302

Message Networking Configuration

Each remote site must be enrolled in your system and the administrator at each remote site must enroll your site as a

remote site on their local system.

Gather the information for each site and determine which sites need to communicate with each other before configuring

a messaging network. Then configure the sites as follows:

1. Determine which protocol to use for communicating with each site.

See About Networking Protocols.

2. Add each remote site to the network.

See Adding a New Remote Site.

3. Configure each remote site.

See Configuring General Parameters for a Remote Site.

4. Configure message delivery for each site.

See Configuring Message Delivery for a Remote Site.

5. Configure the local site.

See Configuring the Local Site.