Installation guide

Fax Mail Configuration Steps 298

Configuring Delivery Retry Settings

The fax mail settings control fax header information and fax retry settings. Configure the number of pages allowed in a

fax transmittal, how many delivery attempts are made per delivery set, how many delivery sets to attempt, and the

delay between delivery attempt sets.

To change systemwide fax mail settings

1. In the Navigation Pane, click System > Fax setup.

For detailed field information, see the System > Fax Setup table.

2. Type the system fax phone number in the CSID field.

3. Select Additional TTI to print the original transmission information at the top of each fax page.

4. Select the maximum number of pages per delivery in the Max pages per delivery field.

5. Type the number that the messaging system dials to reach an external line when sending a fax in the Fax outdial

access.

6. Type the number of seconds the system waits after dialing to listen for a fax tone in the Fax connect wait-time.

7. Type the number of times the system attempts to send a fax transmittal in a single set in the Attempts per set

field.

For information about delivery retry settings, see Understanding Fax Delivery Retry Settings.

8. Type the number of minutes the system should wait between delivery attempt sets in the Delay between sets

field.

9. Type the number of delivery attempt sets in the Number of sets field.

10. Type the amount to be trimmed from the top of the fax image in the Trim Top of Document field.

11. Type the wait ring value to specify the number of rings the messaging system waits for a connection after dialing

out in the Wait Ring field.

12. Click Save.