Hardware manual

Electra Elite Issue 8
System Hardware Manual 8 - 47
14.4.4 Installing the Driver on the PC
Using the setup disk provided with the CT(A)-R Unit
install the driver onto your PC. Refer to the CT(A)
installation Guide for instructions on installing CT(A)
setup disks.
14.5 Removing or Installing BS(E)-R Key Unit
To remove this unit:
1. Remove the Line Card and Line Panel from the Multiline
Ter minal.
2. Pull the tab on the right side of the key unit and lift out the unit
to the left as shown in Figure 8-62 Removing Key Unit.
To install this unit:
1. Insert the two tabs on the left of the key unit in the slots as
shown in Figure 8-63 Installing Key Unit.
Figure 8-62 Removing Key Unit