Hardware manual

Electra Elite Issue 8
System Hardware Manual 8 - 29
5. When an adapter is installed for the first time in a terminal, the base
cover on the Multiline Terminal must be modified. Two adapters can
be installed in the terminal, and two separate cutouts are provided.
Remove the applicable cutout/cutouts on the bottom of the base plate
with nippers. When only one adapter is being installed and it needs
an AC-R Unit for power, remove only the Right cutout as shown in
Figure 8-39 Modifying Base Cover.
6. Turn the base plate with bottom down and release two tabs at the top
for each end cover (shown shaded) corresponding to applicable base
plate cutout/cutouts and remove the cover/covers.
7. Remove the applicable dummy end/ends with nippers.
8. When An AC-R Unit is required for power, remove the cutout on the
right side of the base plate (with the bottom facing up) to
accommodate the power adapter cord.
Figure 8-39 Modifying Base Cover