Hardware manual

Issue 8 Electra Elite
8 - 14 Installing Electra Elite IPK and D
term
Series i Equipment
6. Install the plastic panel over the line card and push the
corners of the Plastic panel until they click in place. Refer to
Figure 8-17 Installing Plastic Panel on DTH/DTR Multiline
Ter minal .
SECTION 8
A
DJUSTING DTH/DTR
M
ULTILINE TERMINAL
H
EIGHT
The base plate on DTH/DTR Multiline Terminals is hinged. The
bottom part can be adjusted to raise or lower the terminal height.
1. Turn the Multiline Terminal upside down, grasp as shown in
Figure 8-18 Raising DTH/DTR Multiline Terminal Height, and
pull up until the Base Cover latches click.
Figure 8-17 Installing Plastic Panel on DTH/DTR Multiline
Terminal