Hardware manual

Electra Elite Issue 8
System Hardware Manual 7 - 53
3.16.2 Connecting the Printer to the KSU
When using the charge control ability, connect the printer
to the KSU to allow the printing of the charge data.
Connect the printer to the serial port on the side of the
KSU with an RS-232C straight cable. Use the COM 2 port
to connect the printer.
3.16.3 Remote Programming Using the Built-in Modem (Modem
Kit Unit)
PC programming abilities include Remote Programming.
Connect the CO line to the modem extension number.
The following characteristics apply to the built-in modem.
Figure 7-66 Connecting a PC to the KSU
Characteristic Value
Baud Rate 14.4Kpbs
Parity None
Stop Bit 1
Data Bit 8