Hardware manual

Issue 8 Electra Elite
6 - 12 Installing Electra Elite Multiline Terminals
SECTION 5
C
ONNECTING DCU
A
TTENDANT CONSOLE
TO A MULTILINE
T
ERMINAL
An Attendant Console can be attached to a Multiline Terminal using the
following procedures.
1. Turn the Multiline Terminal and the Attendant Console face down.
2. Using the joining plate provided with the Attendant Console, attach
the plate to the Multiline Terminal and the Attendant Console.
3. Connect the line cord and the AC adapter to the indicated locations
on the bottom of the Attendant Console.
4. When the Attendant Console and the Multiline Terminal are properly
connected, they sit side-by-side as shown in Figure 6-14 DCU
Attendant Console and Multiline Terminal.
5. Make sure that the AC adapter, supplied with the Attendant Console,
is used. Using a different AC adapter may cause problems. Check
that the supplied voltage matches that specified for the adapter and
plug it in an outlet.
Figure 6-13 Connecting the Line Cord and AC Adapter when Installing a
DCU Attendant Console
Line Cord Jack
AC Adapter Plug