Hardware manual

Issue 8 Electra Elite
5 - 142 Installing Electronic Telephone Units
7.7.3 Installation Procedure
7.7.4 Installation Procedure
1. Ensure that Switch S3 is in SHUTDOWN.
2. Insert IPCA-U( ) ETU in Electra Elite IPK KSU.
3. Connect LAN cable to the LAN.
4. Ensure that Switch S3 is in RUN.
5. Wait for the green AP1 LED to come On.
7.7.5 Shut Down Procedure
1. Ensure that Drive LED is not flashing.
2. Place Switch S3 in SHUTDOWN.
3. Wait for red SHUT DOWN LED to come On.
4. Remove the IPCA-U( ) from the KSU.
When installing this ETU, make all ETU DIP
switch setting changes before inserting it in
the KSU.