Hardware manual

Issue 8 Electra Elite
3 - 2 Hardware Requirements
SECTION 5
P
ROGRAMMING FROM
A MULTILINE
T
ERMINAL Programming for the Electra Elite 192 system is accomplished through PC
Programming. As an added convenience, programming can be
accomplished using Electra Elite or Electra Professional Multiline
Terminals with LCD. Programming should be used after the system is
installed and initial assignments are made. Using the Multiline Terminal is
a quick way to access system data and make changes. To program from a
Multiline Terminal one of the following terminals is required.
DTP/DTH/DTR-8D-1 TEL
DTU-8D-2 TEL
DTP/DTH/DTR-16D-1 TEL
DTU-16D-2 TEL
DTP/DTH/DTR-32D-1 TEL
DTU-32D-2 TEL
DTH-16LD-1 TEL
ITH-8D-2 TEL
ITH-16D-2 TEL
ETW-16DC-1/2 TEL
ETW-16DD-1/2 TEL
ETW-24DS-1/2 TEL
SECTION 6
E
LECTRA ELITE
R
EMOTE PC
P
ROGRAMMING The Electra Elite 192 system can be programmed from a remote location
using a personal computer.
6.1 Remote Programming
To provide remote programming the following hardware is
required:
Analog CO Trunk or system SLT Port (not needed if the
optional internal modem is used)