Instructions

DC2412-UPSD | DC2412-UPS-LDD | UPSIC-1205D | UPSIC-2403D
13
Deutsch
12.2 Kurzübersicht Pinbelegung und DIP-Switch-Einstellungen
DIP-Switch-EinstellungenPinbelegung RS232 / D-SUB
PIN SIGNAL
1
DCD at PC – Detection cable connected
2
TXD (is connected to RXT at PC)
3
RXD (is connected to TXD at PC)
4
Shutdown signal detection
5
GND
6
DSR at PC – Detection caps loading status
7
RTS at PC – Supply voltage
8
CTS at PC – Power Fail detection
9
N/A
Pinbelegung RL / PBR
PIN SIGNAL
04 / RL Relay connection
03 / RL Relay connection
02 / PBR – (V –) Shutdown-Signal (Impuls 200-400 ms)
01 / PBR + (V +) Shutdown-Signal (Impuls 200-400 ms)
Pinbelegung IN / IGN / OUT
PIN SIGNAL
05 / IN + V + Input
04 / IN – V – Input
03 / IGN Ignition signal (nur DC2412-UPS-LDD)
02 / OUT + V + Output
01 / OUT – V – Output
1
ON
23456
CAPS FULL
SD(RB)PF
Shutdown Timer
PIN 2 1
No Reboot ON ON
Reboot after 10s OFF ON
Reboot after 30s ON OFF
Reboot after 60s OFF OFF
ON Output released
when V
CAP
over 90 %
Output release
PIN 3
Power Fail (PF) - Timer
6 5 4 PIN
ON ON ON Software
OFF ON ON 3s
ON OFF ON 8s
OFF OFF ON 20s
ON ON OFF 40s
OFF ON OFF 60s
ON OFF OFF 100s
OFF OFF OFF 150s