Specifications

SETUP

NMP200 parameters are all adjustable using the Windows

95/98/NT/2000 ’BiampWin’ software and serial cable provided with the unit.

BiampWin software provides programs for various ADVANTAGE

products, including the NMP200. The NMP200 program includes several

control screens, which are described on the following pages. Once the software is started (and Comm Port Configuration is set), the

control screens are accessed via the drop-down menus at the top of the opening screen. The Main

screen appears whenever an NMP200

file is opened. Gain Matrix #1

, Gain Manager, EQ, Gain Matrix #2, & Delay screens are then available from the Main screen. Logic

Definition, Button Definition, & Configuration Options screens are also available from the Configure NMP200 menu. The File menu

provides functions such as save, open, download, etc. The Settings

menu recalls the Comm Port Configuration screen. The Window

menu arranges the active product screens. The Help

menu explains the available adjustments. To install BiampWin Software: Select

‘Run’ from the ‘Start’ menu, and enter A:\SETUP. System Requirements

: Windows

95/98/NT/2000 with 5MB of available hard disk space

(serial port required for ‘on-line’ operation).

MAIN SCREEN

The Main Screen is used to adjust NMP200 input/output levels, to access the processing control screens, and to store/recall Presets 1~16.

Adjustments are made with the computer mouse (or keyboard). Input, Noise, Output 1, & Output 2 levels are adjusted by dragging the

corresponding ‘faders

’ up or down. These are the analog signal input & output circuits. ‘Meters’ are provided on each channel to display

input/output levels at specific points along the digital signal processing paths, and at the analog outputs. NOTE: For best performance,

adjust levels so the meters show occasional peaks in the yellow area, but never to the top (red). Output 1 Mute & Output 2 Mute

will toggle

the respective output signal on/off, as well as indicate the output muting status. Logic Inputs

indicators will light whenever the respective

Logic Inputs are turned on via external remote control (see Logic Inputs on pg. 13). Preset

buttons recall the corresponding presets from

non-volatile memory. Presets must first be created & stored by the user (no factory presets). The Store

button opens a menu for storing

current settings in any of the Presets 1~16. Presets may be stored and recalled (in total or in part) via remote control (see Logic Input

Definitions screen on pg. 10). The title bar across the top of the Main screen will indicate the Device #, the custom Device Name, and the

model of product being controlled. BiampWin Software can operate ‘off-line’ (with no product connected) by opening a ‘new’ file for the

desired product. The Device # for ‘off-line’ files is assigned sequentially as a negative number.