Technical information

ANEM Operating ManualANEM Operating Manual
Page 13
3.4 Noise reduction levels.
4 or 8 levels of noise reduction are available. The amount
of noise and tone reduction is shown in the table below.
leveL
)4(
leveL
)8(
noitcudeRenoT noitcudeResioNetihW
1Bd4Bd9
12 Bd5Bd11
3Bd6Bd31
24 Bd8Bd51
5Bd61Bd71
36 Bd12Bd02
7Bd52Bd42
48 Bd56Bd53
Table 2. Tone and noise reduction levels.
The column marked level (4) shows the noise and tone
reduction when operating the module with 4 levels, and
the level (8) column for 8 levels.
Holding down the DSP select button will continuously
change the DSP level. When the desired level has been
reached, release the button. The module will retain this
level until it is changed.
The ANEM is factory set up and ready for use. If you are
using the module in an application which requires
adjustment. For the optimum performance refer to section
4 for more information.
3. Module Operation.
Page 16
Figure 11. Sensitivity.
0
0.5
1
1.5
2
2.5
0 50 100 150 200
Input voltage (mV)
Output power (W)
R
L
= 8W
R
L
= 4W
V
S
= 16V
f = 1KHz
Section 4 contains information on adjusting the operation
of the ANEM. The module is supplied factory set and under
normal circumstances no further adjustment is necessary.
The following information is for guidance only and any
adjusments to the DSP circuit should only be carried out
by those who have a technical understanding of what they
are doing.
3. Module Operation.