Technical information

ANEM Operating ManualANEM Operating Manual
Page 11
To listen to the demonstration modes, or change the
number of DSP levels it is necessary to put the module
into the set up mode.
To do this, ensure the module is Off. Press and hold the
DSP level button. Turn on the module and a 2 tone
beep will be heard indicating that the module is in the
set up mode.
Releasing the button after the first 2 tone beep will enter
demonstration mode 1.
Releasing after the second 2 tone beep will enter
demonstration mode 2.
Keeping the button depressed with change the number
of levels available. 4 beeps will indicate 4 level mode
and 8 beeps 8 levels. Release the button when the
desired level is reached.
The module will return to normal operation after this.
The colour of the LED will indicate the mode of operation.
edomPSDsleveL4sleveL8
FFODEREGNARO
NONEERGNEERG
Table 1. LED mode indication.
3. Module Operation.
Page 18
4.1 Module Layout.
Figure 14. ANEM PCB and controls
Input
level set
(P2)
Output
level set (P1)
Input overload
indicator LED
Audio
bypass
relay
Note:
Wiring and heatsink obmitted for
clarity
Sounder
volume (P3)
4. Technical Information.
The following diagram shows the internal layout of the
ANEM printed circuit board.
In order to access the printed circuit board the case needs
to be removed.
Carefully pull the sides of
the case outwards, until the
upper section can be
removed. When re-
assembling the module
enusre that none of the
wires become trapped in
the case halves.
Figure 13. ANEM case dis-assembly detail.
4. Technical Information.