Operating instructions

Radio Mate Operating Instructions.Radio Mate Operating Instructions.
Page 6
3. Modulation.
In this mode the keypad will select an operating mode at the
single press of a button.
Press the Mod for Modulation mode. The LED will illuminate
YELLOW.
Pressing the appropriate button i.e. USB, AM, FM etc. will change
the radio over to that mode.
Press:
• 1 for USB
• 4 for LSB
• 7 for AM
• 2 for FM
• 5&0 for FMN
• (not on FT817 it will lock up - battery removal required)
• 8 for PKT
• 3 for CW
• 6 for CW-R
• 9 for DIG
4. Direct frequency input.
The operating frequency can be entered directly using the numeric
keypad. To enter the direct frequency input mode - press Dir, the
LED will illuminate GREEN.
To illustrate the use of the mode is illustrated by the examples on
the following pages.
Page 7
For example with the radio reading 145.500
to change to 145.400
press .4 Ent new reading is 145.400
Note:
Entering .400 would also give same result.
To change to 144.300
press 4.3 Ent new reading 144.300
(entering 4.300 would also give same result)
For example with radio reading 144.300
press 5.5 Ent and you are back to 145.500
entering .525 new reading 145.525
Note:
When entering 3 digits after the decimal point there is no need to
press the enter button on pressing the third digit a double beep is
heard and radio is automatically updated.
To go to HF
press 007 Ent new reading 7.525
press .010new reading 7.010
entering 14 Ent new reading 14.010
To change from 14.010 to 3.500 you need to remove the 10 from
the 14 this is done by using a leading zero
enter 03.500 new reading 3.500