Operating instructions

Radio Mate Operating Instructions.Radio Mate Operating Instructions.
Page 4
 Turn the Radiomate off
 Turn the radio on
FT-817 - only
 Press Func button to enter sub menu set cat rate to 9600 Baud.
 Press and hold Func to store.
FT857 & FT897
 For the FT857, and FT897 press func button to enter
submenu and set the radio to CAT mode. Check baud rate is
9600.
All models
 Turn off radio
 Plug Radio mate into cat socket (being very careful not to bend
the pins) Turn on the radio. Turn on the Radio Mate.
 The LED on the Radio Mate will glow red and a beep should
be
heard approx 3 seconds after power up.
 With the LED glowing RED the Radio mate is in Memory/Band
change mode.
Note:
The CAT port remains powered on the FT-817, even when the radio
is switched off. When the radio or keypad is not in use, switch the
keypad off.
1. Set up.
Connecting and setting up the Radio Mate. (See your radio user
manual for more information on setting up the CAT interface).
Page 9
DSP noise cancellation built into a compact
speaker unit. The unit provides an easy to
install solution to noise reduction and easily
connects to the extension speaker socket or
headphone socket of your equipment.
Supplied with a fused power lead.
NES10-2 MKII Noise Eliminating speaker.
NEIM1031 In-line module.
The NEIM1031 provides a flexible solution to noise
reduction and easily fits between your equipment
and speaker.
The unit is also equiped with line level inputs and
outputs, and a 3.5mm mono headphone socket.
Supplied with a fused power and audio lead.
ANEM Noise Away.
Easy to use, simply fits between your
equipment and extension speaker. Audio bypasses module when
the power is switched or removed. All the DSP functions are con-
trolled by a single button. The unit is ompact and can be mounted
out of the way.
Supplied with hook and loop fastener, fused power cable and
audio lead.
1 - Plug in Audio
2 - Connect Loudspeaker
3 - Connect Power
New ANEM “Noise Away”
DSP Noise Cancelling as Easy
as 1-2-3