Installation manual

Page 14
6. Turn the radio equipment on and set the audio volume to your
own personal taste, making sure that you are not over driving
the speaker and causing distortion. Adjust the sensitivity control
knob on the top of the speaker if required to obtain your optimum
setting.
7. Tune into the station or channel you require.
8. Turn the noise cancelling on, the front panel LED changes from
red to green indicating the noise cancellation is active.
9. Adjustthelterlevelsettingifrequiredtoremovehigherlevels
of noise and improve the intelligibility and clarity of the signal.
Note:
The switches may
be adjusted using
a blunt implement
such as ballpoint
pen.
1WS 2WS 3WS leveL noitaunettA
NO NO NO
1 Bd9
NO NO FFO
2 Bd11
NO FFO NO
3 Bd31
NO FFO FFO
4 Bd51
FFO NO NO
5 Bd71
FFO NO FFO
6 Bd02
FFO FFO NO
7 Bd42
FFO FFO FFO
8 Bd53
Page 19
With the noise cancellation switch in the off position, make
sure that you have the sensitivity control on the NES10-2
fully counter clockwise or thereabouts. Now tune your radio
communications equipment until you have a good clear signal
with good volume.
The volume from the speaker is low and cannot be
increased:
The speakers are designed to work with the external
speaker sockets of radio communications equipment, and
although it will work with some earphone and headphone
sockets, there may be occasions where the signal output
from these types of output sockets is not enough for the
speakers electronics to process the signal effectively.
bhi have another product that will work with these levels of signal
, the NEIM1031 (Noise eliminating In-line Module). Please
contact bhi for more information. See end of operating manual
for contact information.
Sometimes there is a short delay before the noise
cancellation is active.
This is due to the time the DSP takes to start processing the
signals. This gives the oppportunity to check that the DSP is
not taking out any detail from the signal.