Installation manual

Page 9NEMS operating manual
Figure 5. Audio connections.
Remove the audio connector cover from the rear of the speaker.
Insert the audio cable through the hole in the cover. The piano
key connectors are opened by pressing the bottom of the coloured
lever. Insert the wires into the correct speaker connection as
shown in the above diagram. Ensure that the blade of the
connector is clamping the exposed strands of the wire and not
the insulation. Push the cover over the connections.
Run the audio cable to the radio. Ensure the radio is switched off
and connect the 3.5mm mono jack plug to the socket marked
extension speaker (using any adapter if required).
2. Installation.
Audio
Cable
Rear view
of speaker
Wiring
cover
Piano
key
connectors
Connect the Red wire to the +Ve Red connector.
Connect the white wire to the -ve Black connector.