Specifications

Technical Support: 877-995-8155 15
MENU FLOW CHART
PARAMETER MENU
TCA (timer to close) [sec.]
(default 10 sec., min 3 sec., max 60 sec.)
Motor 1 torque [%]
(default 50%, min 1%, max 99%)
Motor 2 torque [%]
(default 50%. min 1%, max 99%)
Motor 1 torque slow-down [%]
(default 5%, min 1%, max 99%)
Motor 2 torque slow-down [%]
(default 5%, min 1%, max 99%)
Opening delay time [tenths of a sec.]
default 10 = 1 sec., min 10 = 1 sec., max 100 = 10 sec.)
Closing delay time [tenths of a sec.]
(default 10 = 1 sec. , min 10 = 1 sec., max 100 = 10 sec.)
Motor 1 normal speed time [sec.]
(default 15 sec., min 1sec., max 30 sec.)
Motor 2 normal speed time [sec.]
(default 15 sec., min 1sec., max 30 sec.)
Slow-down speed
0= Slow-down disabled
1 = 50% of normal speed
2= 33% of normal speed
3= 25% of normal speed
Zone (serial connection – requires SCS card)
(default 0, min 0, max 127)
LOGIC MENU
TCA (automatic closing)
Default: OFF, Enabled: ON, Disabled: OFF
3 STEP (3 step/4 step)
Default: OFF, 3 step: ON, 4 step: OFF
IBL OPEN (commands ignored on opening)
Default: OFF, Enabled: ON, Disabled: OFF
FAST CLS (closing on photoeye disengage)
Default: OFF, Enabled: ON, Disabled: OFF
PHOTOC. OPEN (photoeye ignored on opening)
Default: OFF, Enabled: ON, Disabled: OFF
TEST PHOT (photocell test – requires dierent wiring if ON,
see instruction manual for further details)
Default: OFF, Enabled: ON, Disabled: OFF
1 MOT ON (single operator installation)
Default: OFF, Single op. install.: ON, Dual op. inst.: OFF
BLOC PERSIST (lock hold - use only if positive stops installed)
Default: OFF, Enabled: ON, Disabled: OFF
START-CLOSE (terminal 16 as CLOSE)
Default: OFF, Term. 16: CLOSE: ON, Term. 16 START: OFF
FIXED CODE (xed/rolling code receiver)
Default: ON, Fixed code: ON, Rolling code: OFF
RADIO PROG. (radio learn)
Default: ON, Enabled: ON, Disabled: OFF
MASTER (the board is a “master board” – requires SCS card)
Default: OFF, Master board: ON, Slave board: OFF
Warning: the logic MASTER has no relation to
single/dual operator installation, it is used only if
serial connection with multiple boards is required.