Specifications

Technical Support: 877-995-8155 13
CONTROL BOARD QUICK PROGRAMMING
NAVIGATING THROUGH THE MENUS:
•The“OK”buttonisusedfor:switchingonthedisplay,conrmingchangestothe
programming, entering the menus.
•The“+”buttonisusedfor:scrollingupthemenus(goupinthemenusasshownonpage
15), increasing values.
•The“-”buttonisusedfor:scrollingdownthemenus(godowninthemenusasshownon
page 15), decreasing values.
•The“+”and“-”buttonspushedatthesametimeareusedfor:gettingbackonelevelinthe
menus, discarding changes to programming, exiting from the programming mode (turning
off the display).
FINALIZING THE INSTALLATION:
•Turnoffpowertothecontrolboard.
•Connectanyexternalcontroldeviceaccordingtowiringdiagramonpage17.
•Turnonpowertocontrolboard.CheckredpowerlightonLibra
control board.
ADDING TRANSMITTERS TO THE RECEIVER
1. Turn on the display (by pressing twice the “OK” button).
2.Scrolldown(“-”button)to“RADIO” menu and press “OK”.
3. The display will show “ADD START”. Press “OK”
4. The display will show “HIDDEN BUTTON”. Press the two front buttons
of the transmitter at the same time as shown on Fig. A.
Note: Older models will have the hidden button on the back side of the
transmitter as shown on Fig. C.
5. The display will show “DESIRED BUTTON”. Press the button you want
to activate the gate with as shown on Fig. B.
6. The display will show “ADD START” . Repeat the programming
procedure from step #3 to install other transmitters.
7. Switch off the display by pressing “+” and “-” buttons at the
same time twice.
Fig. A
Fig. B
Fig. C