Specifications

10 Technical Support: 877-995-8155
WIRING INSTRUCTIONS
Refer to page 17 for terminal layout
CONNECTING THE POWER:
CONNECTING THE ANTENNA:
CONNECTING THE PHOTOEYE (THROUGH BEAM):
•Itisrecommendedtouseaseparatelinewithitsown
circuit breaker for the gate automation.
•Connecttheline wire of the 110 volt power source
to terminal L of the Libra control board.
•Connecttheneutral wire of the 110 volt power source
to terminal N of the Libra control board.
•Connecttheground wire of the 110 volt power source to
ground terminal of the Libra control board.
Wire not supplied
•ConnecttheantennacabletotheLibracircuit
board. Strip cable and connect the core wire to
terminal 23 and the shield wire to terminal 24.
Note: This terminal block is not removable. The
connection of the antenna is easier to complete
by removing the board from the small black
enclosure.
•Connect#1&#2ofthephotoeyereceiverto
terminal 11 & 12 of the Libra control board.
•Connect#3&#5ofthephotoeyereceiverto
terminal 15 & 18 of the Libra control board.
    Removejumperwire.
Wires not supplied.
•Connect#1&#2ofthephotocelltransmitterto
terminal 11 & 12 of the Libra control board.
Wires not supplied.