Datasheet

EN
GRAPHICS CARD FULL INSTALL MANUAL
4
Version 2.0 INT
Step 6A. If the identified slot is occupied by another add-in card, first
remove any screws and/or retention mechanisms holding it in place,
then pull out the card.
Step 6B. If the identified slot is unoccupied, remove the
metal cover from the rear of the case that corresponds to
the graphics card slot on the motherboard.
Step 7. Align your new BFG Tech graphics card with the
open slot and press firmly until the card is fully seated.
Step 8. Secure the new card in place with the screw and/or retention
mechanism you removed in Step 6.
Step 9A. If your new graphics card requires power via a 4-pin Molex
connector, find an available matching connector from your power sup-
ply and attach it to the graphics card. If you do not have an available
4-pin Molex connector, disconnect a matching connector from anoth-
er device, attach it to the included power splitter cable, then attach
one end of the power cable to the graphics card and the other end
to the device you disconnected prior.
Step 9B. If your new graphics card requires power via a 6-pin PCI Express connector, find an
available matching connector from your power supply and attach it to the graphics card. If you
do not have an available 6-pin PCI Express connector, locate two free 4-pin Molex connectors,
attach them to the ends of the included power cable, and then attach the power cable’s 6-pin
connector to the graphics card.
Step 10. Replace the computer’s side panel or cover.
Step 11. Connect the monitor cable to the matching connec-
tor on the BFG Tech graphics card you just installed. If your
monitor has a DVI-D or DVI-I cable then connect it to the
white DVI-I connector. If your monitor has a VGA cable,
connect it to either the blue VGA connector or to an
included DVI-to-VGA adapter and then to the white DVI-I
connector. When you are done, plug the power cord back into
the computer.
Metal
Cover
4-PIN Molex Power Cable
6-PIN PCI Express Power Cable
PCI Express
AGP
New
Card
Power
Cord