User's Manual

WiPR Quick Start Guide Version 1.4. F1-90-2248-A
Battery Status and Charging
Should the battery voltage fall below a pre-defined warning limit the device will display a warning message accompanied by an audible warning.
If the battery voltage falls below a pre-defined critical level the device will display a warning message accompanied by an audible warning, then the device will power off.
To charge the WiPR, connect on mini USB lead with a suitable power supply e.g. Phone charger. Typical charge time is 2-3 hours.
The device cannot be used while charging. If powered up whilst charging, the charging message will be displayed and the unit will automatically power off.
Error Messages
If a sensor is not triggered the unit shall indicate that no sensor data has been received.
SENSOR NOT DETECTED
SETUP TRIGGE R
Sensor errors are defined as either hardware and/or measurement errors:
SET UP TRIGGER
S E RI A L : 1 2 3 4 5 6 7 8 9 0
P:2.4 Bar T:33C
SENSOR FAULT – H/W AR E
SETUP TRIGGER
S E RIA L :1 2 34 5 6 7 89 0
P:2.4 Bar T:33C
SENSOR FAULT - MEASURE
Or the remaining sensor battery life is low.
SET UP TRIGGER
S E RI AL : 1 2 345 6 7 890
P:2.4 Bar T:33C
SEN SOR FAUL T – BATT LO
Precautions
– Do not drop.
– Avoid storage in extremes of temperature.
– This device is not waterproof, do not immerse in water.
– Do not operate near a heart pacemaker.
Statement of compliance to FCC regulations
Section 15.19: Labelling requirements
This device complies with Part15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Please note that any changes or modifications not expressly approved by BERU f1systems could void the user’s authority to operate the equipment.
Manufacturer: BERU f1systems, Diss, UK
Part Number: F1-100-1290-003
Warranty: 12 months
For full technical data sheet visit:
http://www.thewipr.com/