User's Manual

WiPR Quick Start Guide Version 1.4. F1-90-2248-A
Quick Start Guide
A device that enables the user to test BERU wheel sensors and gather diagnostic information.
Operation
– To turn the device on / off press ▼+ ● button together and hold (auto power off after 2mins if no buttons are pressed).
– Whilst powering up, the device will display the battery status in the bottom right hand corner.
bf1systems
WiPR
433MHz
SW:0.12
- - - - -
MORE TRIGG
– Once the device is powered up, hold it within 20cm of the tyre valve and press ● button (TRIGG) to trigger the sensor.
TRIGGERING
X X X X X X
– Once the sensor has been triggered it will transmit data, and the tyre pressure screen will be displayed. The sensor serial number will also be displayed at the
bottom of the screen.
MOR E
MOR EMOR E
MOR E TRIGG
TRIGGTRIGG
TRIGG12345678 90
12345678 9012345678 90
12345678 90
– Press ▼ (MORE) to display the current tyre temperature.
MOR E
MOR EMOR E
MOR E TRIGG
TRIGGTRIGG
TRIGG12345678 90
12345678 9012345678 90
12345678 90
– Press ▼ (MORE) to scroll to the next display that will show the sensor serial number, tyre pressure, temperature, RBL (Remaining Battery Life in months),
sensor MODE and sensor generation.
MOR E
MOR EMOR E
MOR E TRIGG
TRIGGTRIGG
TRIGG
SER No: 1234567 890
TEM P: 24C
MODE: 41
P: 2.2bar
RBL: 118
GEN
GENGEN
GEN :
::
:2
22
2
Settings
You can access and change the settings of your device by pressing and holding ▼ for 2 seconds; this will give you the following options.
– Mode
The mode settings page allows the selection of 433MHz or 315MHz and LIVE or TRIGGERED operating mode.
Select the correct receive frequency prior to triggering or listening for a wheel sensor. See lookup table for reference.
SELECT
SELECTSELECT
SELECT TOGGLE
TOGGLETOGGLE
TOGGLE
SETTINGS-MODE
BAND [433]
TRIG
When the LIVE option is selected, the WiPR will receive datagram’s from all BERU wheel sensors transmitting within the receive range.
When the TRIGGERED option is selected; the WiPR will only receive datagram’s triggered after the TRIGG button has been pressed.
SELECT
SELECTSELECT
SELECT TOGGLE
TOGGLETOGGLE
TOGGLE
SETTINGS-MODE
BAND 433
[TRIG]
Hold ▼ for 2 seconds to access the UNITS page.
– Units
To toggle between temperature and pressure press ▼
You can change either of these settings by pressing ●. This will toggle between °C / °F for the temperature, and bar / psi for the pressure.
SELECT
SELECTSELECT
SELECT TOGGLE
TOGGLETOGGLE
TOGGLE
SETTINGS-UNITS
PRESSURE [bar]
TEMPERATURE C
SELECT
SELECTSELECT
SELECT TOGGLE
TOGGLETOGGLE
TOGGLE
SETTINGS-UNITS
PRESSURE bar
TEMPERATURE [C]
Hold ▼ for 2 seconds to access the AUDIO page.
– Audio
You can toggle the LF transmission and RF reception audible indicators on and off.
SELECT
SELECTSELECT
SELECT TOGGLE
TOGGLETOGGLE
TOGGLE
SETTINGS-AUDIO
RFRx [ON]
Hold ● for 2 seconds to return to the operation screens at any time.