WiPR Wireless Pressure Reader Quick Start Guide WiPR Quick Start Guide Version 1.4.
Quick Start Guide A device that enables the user to test BERU wheel sensors and gather diagnostic information. Operation – – To turn the device on / off press ▼+ ● button together and hold (auto power off after 2mins if no buttons are pressed). Whilst powering up, the device will display the battery status in the bottom right hand corner. bf1systems WiPR 433MHz SW:0.
Battery Status and Charging Should the battery voltage fall below a pre-defined warning limit the device will display a warning message accompanied by an audible warning. If the battery voltage falls below a pre-defined critical level the device will display a warning message accompanied by an audible warning, then the device will power off. To charge the WiPR, connect on mini USB lead with a suitable power supply e.g. Phone charger. Typical charge time is 2-3 hours.
