User's Manual

Wireless Mini Analyser User Manual
Wireless Mini Analyser User Manual V1_06
1_04
9 of 32
RD096 071112
5.2 USB mains power supply
The USB mains power supply is supplied with the purpose of supplying power directly to the wireless modules that
are used with the mini analyser.
The power supply converts 230V AC mains voltage into 5V DC at 1.0A
The power supply should only be used in conjunction with the USB cables that have been supplied with the mini
analyser.
For all safety advice please refer to the safety advice page which can be found at the start of this document.
Once the correct pin adaptor has been selected, slot it in at around a 30-45° angle then press down until it is locked
into place as shown in the images below
The USB cable should be inserted into the socket before the supply is connected to mains. See image 1 below.
The USB cable can now be plugged into the wireless module unit via the micro USB socket. See image 2 above.
Once everything is connected the plug can be connected to mains and power can be switched on.
The pin adaptor can be removed by pulling the release down as shown in the image below.
1
2