User's Manual

Wireless Mini Analyser User Manual
Wireless Mini Analyser User Manual V1_06
1_04
27 of 32
RD096 071112
The Mini Analyser communication speed is now correct to function with the bf1systems Analyser Bootloader
software. Close the terminal emulator and start the bootloader software. The screenshot below shows the
bootloader software.
The following steps should be followed to update the firmware:
 Ensure a known good battery is used or the analyser is powered from the charger during the update.
 Confirm ‘System: Live’ is shown in the bottom right corner.
 Select the <Update Motherboard Firmware> button. This will call up a file dialog, where the required .fwr file
can be selected.
 Once the file is selected the Mini Analyser will auto power off ready for update (Status : Starting Bootloader)
 Press the Action Key on the Mini Analyser to start the motherboard bootloader.
 The bootloader program will now erase the old firmware (Status : Erasing FLASH) and program in the
selected firmware file (Status : Programming FLASH). The progress of the programming operation can be
monitored via the Programming Status bar, and the Status field at the bottom of the screen.
 When programming completes (Status: Starting Firmware), the new firmware can be started by pressing the
Action Key to power on the Mini Analyser
The firmware update is now complete.