User's Manual

Wireless Mini Analyser User Manual
Wireless Mini Analyser User Manual V1_06
1_04
20 of 32
RD096 071112
6.2.4 ‘gencfg’ Command
By default the Wireless Mini Analyser is configured to auto detect and decode RF datagrams from Ge1, Gen2 and
Gen 3 sensors. In some situations the user may wish to configure the unit to receive only sensors of a specific type.
This can be achieved via the ‘gencfg’ terminal command.
Sending the ‘gencfg’ command with no argument at the USER1> prompt will result in the current setting, and
available options being returned by the Wireless Mini Analyser:
USER1> gencfg
Current sensor gen configuration 4
Sensor gen configuration 0 = GEN1
Sensor gen configuration 1 = GEN2
Sensor gen configuration 2 = GEN3
Sensor gen configuration 4 = Auto
USER1>
To modify the setting the ‘gencfg’ command should be sent with the appropriate argument. The Wireless Mini
Analyser will respond with a message indicating the change has taken place.
USER1> gencfg 2
Sensor gen configuration 2 set
If the terminal is not configured for local echo then the information sent at the USER1> prompt will not be visible on
the terminal.
6.3 Setup Menu
The setup menu gives access to status and configuration information for the Wireless Mini Analyser. Pressing the
power button and left arrow button at the same time accesses the setup menu. The setup menu is entered at the
<Power Settings> menu page. Other available pages are accessed using the Left Arrow / Right Arrow navigation
buttons.
The setup menu can be exited by pressing and holding the Left Arrow navigation button. This will move the user to
the top level menu.
The <Battery Status> page indicates the current state of charge of the Mini Analyser internal battery, and also allows
the user to turn on and off the display backlight . The backlight state is toggled by pressing the power button.
Pressing the power button at the <RF Receive> top level menu page returns the user to the default sensor display
page.
Setup
System Info
Up Ok Down
Setup
Contrast
Up Ok Down
Setup
Channel Config
Up Ok Down
Setup
Power Settings
Up Ok Down
Setup
Beep / LED 1
Up Ok Down
Setup
Beep / LED 2
Up Ok Down
RF Receive
Up Ok Down
Setup
Up Ok Down
Battery Status
<######## >
Up Backlight Down