Specification
• READ ALL INSTRUCTIONS
• WARNING - RISK OF FIRE OR ELECTRIC SHOCK. INSTALLATION REQUIRES KNOWLEDGE OF LUMINAIRE ELECTRICAL
SYSTEMS. IF NOT QUALIFIED, DO NOT ATTEMPT INSTALLATION AND CONTACT A QUALIFIED ELECTRICIAN.
• WARNING - THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH APPLICABLE INSTALLATION CODES BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
• WARNING - INSTALL THIS KIT IN ACCORDANCE WITH THE INSTALLATION INSTRUCTIONS ACCORDING TO THE
DIMENSIONS AND SUPPLY VOLTAGE AND AMPERAGE RATINGS SHOWN.
• DO NOT INSTALL THE LUMINAIRE NEAR ANY HEAT SOURCE.
• TO AVOID INJURY OR DAMAGE TO THE LUMINAIRE, PLEASE ENSURE THAT THE POWER LEADS AND SCREWS ARE SECURE
BEFORE CONNECTING POWER.
• ALWAYS ENSURE THAT POWER IS OFF, AND THE LUMINAIRE HAS COOLED, BEFORE PERFORMING ANY MAINTENANCE,
CLEANING, OR ADJUSTMENTS TO THE LUMINAIRE.
• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment on and o, the user is encouraged
to try to correct the interference by one or more of the following:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the lighting unit and receiver.
3. Connect the lighting unit into an outlet on a circuit other than the outlet which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for assistance.
NOTE: Please note that changes and modications are not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Conforms to standard CAN-ICES 005(B) /NMB-005 (B)
TABLE 1
A
B
C
25.59”
PRODUCTS COERED
odel
Lumen outut
B
C
in Cutout
ax Cutout
" CCT
2
(K)
2(L)
9WWW
"
9"
2"
"
"
" CCT
2(L)
W9W2W
9"
2"
"
9"
"
" CCT
2(L)
W2WW
"
2"
"
"
9"
(866) 786-1117 • www.BeyondLEDTechnology.com
11
LED COMMERCIAL DOWN LIGHTS
WHITE SKY
TM
2nd Gen
BEYOND
L E D T E C H N O L O G Y