Use and Care Manual
3
LED T8 TUBES
MR
TM
Installa�on Diagram
Wire Diagrams
Warning
1. Turn off the power.
2. Remove diffuser (if provided).
3. Remove the fluorescent tubes. Please dispose of these items properly as they contain mercury
4. Cut the wires as shown in the diagram.
5. Make the new wire connect to branch circuit as shown.
6. Replace the cover over the wiring channel.
7. Install the led tubes, close the diffuser.
8. Turn on the power
1. These lamps should be installed by a licensed electrician.
2. These lamps should be used indoors (damp or dry loca�ons only). Not suitable for wet loca�on.
3. Make sure tombstones/lamp holder are s�ll in good condi�on and not defected before installa�on.
4. Put LED tubes/G13 pins into right posi�on of the socket, install properly.
5. This device is not suitable for using with emergency exits.
6. These lamps are not suitable to be used with a light dimmer.
If the LED lamp damaged by anyone who didn’t comply with above warning, We’ll not responsible for that.
Beyond LED Technology | 1939 Parker Ct, Stone Mountain, GA, 30087
Due to con�nuous product improvement, informa�on in this document is subject to change.
BEYOND
L E D T E C H N O L O G Y