Installation Guide

[phone] • www.BeyondLEDTechnology.com
Due to continuous product improvement, information in this document is subject to change.
3. Straight Arm Mount
a. Open the side lid of direct bracket, let the power cable go through the direct bracket.
Fix the direct bracket to the end of lamp body with bolt. Let the pole cable go through
the direct bracket. (Figure 3-1)
b. Fix the direct bracket to the square pole with bolt. Connect the power cable to the pole
cable, make sure good protection on the wire connection, and put the wire in the direct
bracket; close the side lid and tighten it, (Figure 3-2) then finish in installation.
c. Notice: Round pole should be with adaptive plate. (Figure 3-3)
Photocell Function