Installation Guide

Beyond LED Technology | 1939 Parker Ct, Stone Mountain, GA, 30087
Due to continuous product improvement, information in this document is subject to change.
1. Slip Fitter Mount
a. Loosen the 4 locking bolts on the slip fitter, connect the wire correctly and put the wire
into pole. Then fasten the locking bolts between slip fitter and the pole (Figure 1-1)
b. Loosen the fixing bolts and adjusting bolts, align the fixture to required angle. Tighten
adjusting bolt and fixing bolts after the angle is confirmed. (Figure 1-1)
2. Yoke Mount
a. Loosen cap fixing screw and take cap off. Loosen fixing bolt, fixed the fixture on the
support and tighten fixing bolts. (Figure 2-1)
b. Let the AC wire go through the support hole and connected correctly. Close cap and
tighten cap fixing screw after AC cable is well placed in the support. (Figure 2-1)
c. Loosen adjusting screws, align the fixture to required angle and fasten the screws.
(Figure 2-1)
Installation Instructions