Specification

9
Beyond LED Technology | 1939 Parker Ct, Stone Mountain, GA, 30087
Due to continuous product improvement, information in this document is subject to change.
Installation
Notice For Users
Trouble Shooting
LED Linkable Strip Fixtures
Crisp Series
LED LINKABLE STRIP FIXTURES
LED Strip Installation Instruction
2-2. DC Motion Sensor:
Step1. Press the screws on both sides of the lamp by hand to open the lamp.
Step2. Assemble the DC sensor to the corresponding position (Figure 13).
Step3. Connect the wires according to the wiring instructions,adjust sensing mode as per demand, and then
assemble the disassembled lamp back. (Figure 14)
3.Backup driver:
Step1. Press the screws on both sides of the lamp by hand to open the lamp.
Step2. Assemble the backup driver to the lamp chassis (Figure 15)
Step2. Connect the wires according to the wiring instructions, and assemble the disassembled lamp back. (Figure 16)
• Please turn off the power before installing or changing assembly parts.
• The input voltage and lamps should be matching, before connecting the power line, please
make sure the wiring section is insulated.
• Only professionals should install and disassemble the lamps.
• Flickering of the light - Turn off the power and turn on again in 3 minutes. If same phenomena
occurs, then call Support.
• Not working - Please check all power connections.