Quick Start Guide

Unite TH – Handheld Transmitter
2
0
be stored immediately in the unpaired receivers. The
status indicator on the receiver will flash yellow ra-
pidly while this happens.
6. Set the switch  back to “Charge only” when the
pairing is finished, so that the charger can only be
used for recharging.
7. Switch on the transmitter and one receiver to check
that they have both been paired successfully.
After a few seconds, the status indicator on the
receiver should light up green and the display should
show the channel name of the transmitter.
8. If you want to clear the stored pairing information,
hold down the “Copy/Reset button  for more than
five seconds. The status indicator  will then remain
permanently green.
6. Technical specifications
DECT RF frequency range . . . . . 1880 - 1930 MHz,
depending on the country
DECT transmission power . . . . . . up to 250 mW (peak),
depending on the country
DECT operating range . . . . . . . . . up to 300 m outside
(line of sight);
the actual operating
range depends upon the
RF output settings, the
surroundings, the signal
absorption, signal
reflection and signal
interference
Operating mode. . . . . . . . . . . . . . . Broadcast and/or
full-duplex on all routes
Encryption. . . . . . . . . . . . . . . . . . . . . AES-256 bit encryption
Display . . . . . . . . . . . . . . . . . . . . . . . . monochrome white OLED
display with high contrast
DECT audio bandwidth
Low quality (SD) . . . . . . . . . . . . . . 50 Hz - 7 kHz (-3 dB)
High quality (HD) . . . . . . . . . . . . . 50 Hz - 14 kHz (-3 dB)
Simultaneously
active microphones . . . . . . . . . . . 1 x handheld transmitter,
max. 2 x via talkback
functionality
Side-tone and
microphone gain . . . . . . . . . . . . . . individually adjustable
Microphone capsule
Transducer type . . . . . . . . . . Condenser
(back electret)
Operating principle. . . . . . . Pressure gradient
Polar pattern . . . . . . . . . . . . . Cardioid