Installation Instructions

Unite AP4 – Access Point
17
english
6.4 Use safety line
The Unite AP4 has two openings through which you can route a safety line to secure the
Unite AP4 additionally again falling down. This is especially recommended for
inallations on age or ceilings.
For the preferred direction of threading, refer to the arrow in the drawing.
7. How to use several Unite AP
A maximum of 8 Unite AP4 can be connected with each other so that 32 channels can be
sent, received or sent and received – depending on the configuration.
• To synchronise the devices, connect the sync signal output  of the fir Unite AP4 to the
sync signal input  of the second Unite AP4.
• Connect the Sync signal output  of the second Unite AP4 to the Sync signal input  of
the third Unite AP4 etc.
• The fir device acts as Sync Maer, each additional device as Sync slave. The Sync
Maer specifies the sync signal on which the sync slaves synchronise.
Attention:
• If several Unite AP4 are used in one room, a minimum diance of 2 m mu be
maintained between the individual units to avoid radio diurbances.
...8
Sync Maer
Sync Slave Sync Slave
Sync Slave
min. 2m
1278
min. 2m