Installation Instructions

Unite AP4 – Access Point
15
english
6.3 Mounting on a VESA adapter plate
1. Attach a VESA 75 x 75 plate with
4 screws via the 4 holes to the
mounting panel. The diances
between the 4 holes are 75 mm each.
Attention: When selecting the screws,
make sure that the screw is flush with
the nut and does not protrude into the
device.
2. Faen the 4 screws on the inside of the
mounting panel with hex nuts.
Size of the nut: M5
3. Remove the cover plates from the
mounting panel by pressing the large
latch.
4. Route all required connecting cables
through the openings of the mounting
panel.
X4 X4