User's Manual

3.3 Setting up

1. Push down the two snap locks on the right and left of the battery compartment and

open it. Now you can adjust the GT/MT switch and the gain control .

2. Make sure that the transmitter and receiver are on the same frequency.

3. The LED of the TS 900 C will flash for a moment when the transmitter is switched on and

indicates the normal battery status. When the LED fails to flash, there is no battery

inserted, the battery is leaking or inserted incorrectly. The battery status of the

TS 900 M can be seen in the LC-Display

4. Connect the microphone or instrument to the input socket . Refer to illustration

below.

3.4 Adjusting the Input Gain

1. Switch on the TS 900 beltpack transmitter with the ON/OFF switch . Turn the gain

control fully anti-clockwise to minimum gain.

2. Speak into the microphone at the maximum level you expect to use. We recommend you

use the letter “U” as a spoken “U” has a relatively good sine wave shape. Adjust the

gain control to the desired gain. On the NE 900 receiver the AF level must not show

any clipping. When miking instruments, play at the maximum level you expect to use.

Opus900_BA_DEF_neu:Opus900_BA_DEF 26.09.2006 14:48 Uhr Seite 62