User Manual

english

TG 100 – Beltpack Transmitter

3.2 How to Operate the Beltpack Transmitter

How to insert or change the batteries

• Take hold of the cover of the battery compartment 

on top at the inlets at the right and left hand side.

• Flap the cover of the battery compartment 

downwards.

• Insert two alkaline batteries, AA 1.5 V or recharge-

able NiMH batteries according to the symbols in the

battery compartment .

• Flap the cover of the battery compartment  up-

wards to close. Magnets ensure a secure fastening.

How to connect a headset

• The transmitter is supplied with a headset which you can connect to the 4-pin mini XLR

connector .

How to turn the transmitter on or off

• Turn on the beltpack transmitter by holding the on-off button  pressed. The transmitter is ready

for operation when the power on LED  will illuminate green. The left LED  on the receiver

will permanently illuminate green.

• If the power on LED  of the transmitter will permanently illuminate red, the batteries are empty.

The left LED  on the receiver will permanently illuminate red. In this case, you should replace

the batteries as soon as possible by new ones or recharge the rechargeable batteries.

How to select or change a channel

• Make sure that transmitter and receiver operate on the same frequency. Switch off the transmitter.

Flap the cover of the battery compartment  downwards.

• Select the channel of the transmitter with the channel selector switch  in the battery compart-

ment according to the channel of the receiver (0 - 7) by using a small screwdriver.

• In order to turn off the beltpack transmitter hold the on-off button  pressed for a few seconds, until

the green power on LED  will go out.

How to adjust the sensitivity

• With the gain switch  you can adjust the sensitivity for close or distant miking:

– Position “Low” for close miking or when connecting a guitar.

– Position “Hi” for distant miking.

– Position “0 dB” for standard miking.

• Adjust the sensitivity so that the middle LED  of the receiver does not, or only briefly, light up

red during loud tones.

How to mount the belt clip

• The beltpack transmitter is supplied with a belt clip to attach the transmitter to clothes, belts, a

guitar strap etc.

• You can remove the belt clip by pulling it from the fixation of the beltpack transmitter.





TG100_B_DE-EN-IT 12.12.2013 10:04 Uhr Seite 27