User's Manual
Synexis – Synexis RP2 Beltpack Receiver
6
2. Synexis RP2 beltpack receiver
2.1 Controls and indicators
Headphone socket, mini jack (3.5 mm)
LED to display operation or charging status
(refer also to the chapter “Synexis chargers”)
On/off and volume control
Set button
Charging contacts
Lid of the battery compartment
Belt clip
Channel selector buttons
OLED display to indicate the channel, battery status, frequency and
channel lock function
Mounting for holding strap
Battery compartment for two 1.5 V batteries or rechargeable batteries
(1600 mAh - 2100 mAh)
2.2 How to insert/replace the batteries
• Remove the belt clip , slide down the lid of the battery compartment to
open the battery compartment .
• Insert the supplied NiMH rechargeable batteries according to the polarity marks.
Before using the receiver for the first time, the rechargeable batteries inside
must be charged e.g. with the Synexis C8 or C10 charger. As an alternative you
can use two 1.5 V AA alkaline batteries.
• If you wish to wear the receiver with a holding strap around your neck, you can
mount a holding strap to the right and left hand side.
• Close the battery compartment by sliding the lid to the top.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.