User's Manual
Synexis – Synexis TS2 Stationary Transmitter
14
5. Synexis TS2 stationary transmitter
5.1 Controls and indicators
On/off switch
Level control microphone input
Level control AUX input
OLED display to indicate channel, AF level, frequency and channel lock function
Channel selector buttons
Set button
Level control headphone
Headphone connection, 1/4" stereo jack (6.35 mm) (Mix from Aux and Input.
On request, Aux only for single interpretation applications.)
Antenna output, 50 ohms, TNC
AUX output, phono RCA, stereo
AUX input, phono RCA, stereo, for MP3 or CD
Input for line or dynamic microphone, balanced, 3-pin XLR
Sensitivity switch for Line level or microphone
Microphone input, unbalanced, 1/4" stereo jack (6.35 mm)
Cable grip
DC connection for power adapter
5.2 Setting up
1. Connect the supplied antenna to the antenna output .
2. Connect the XLR input or the jack input to the output of a mixing console,
interpretation system or a dynamic microphone.
3. Set the sensitivity according to the input level.
Recommendation:
Mic when using dynamic microphones
Line when using interpretation systems, mixing console outputs etc.
4. Depending on the application you can connect an MP3 or CD player to the AUX
input .
5. Make sure the mains voltage shown on the power adapter corresponds to the
local mains voltage.
6. Connect the power adapter to the receiver and to AC power.
7. Switch on the Synexis TS2 .
8. Channel and AF level are displayed .
9. If the transmitter is not operated for a while, the display turns into a “screensaver”
mode (dimmed, continuous display). The AF level is not displayed in the
“screensaver” mode. In order to activate it, press briefly the Set button .
10. To avoid accidental pulling off the power adapter cable, thread the power cable
through the cable grip as shown on the illustrations on the right hand side.
cable grip